| Official Luthiers Forum! http://www-.luthiersforum.com/forum/ |
|
| Mock Weissenborn Style Peghead http://www-.luthiersforum.com/forum/viewtopic.php?f=10102&t=15231 |
Page 1 of 1 |
| Author: | Mackie [ Thu Jan 03, 2008 5:02 am ] |
| Post subject: | |
Following Todd Stocks "Milling A Weissenborn Peghead" tutorial I made this mock peghead. I'm not going to use It, so It has'nt been completed. It's made from Poplar that I got from the local lumber yard. I'm thinking about making the actual one out of curly maple to contrast with the Walnut back and sides. The picture below isn't that good.  ">
|
|
| Author: | Mackie [ Thu Jan 03, 2008 5:09 am ] |
| Post subject: | |
I'll try again using camino.  |
|
| Author: | ozziebluesman [ Thu Jan 03, 2008 12:38 pm ] |
| Post subject: | |
Very stylish Mackie. The poplar dosen't look out of place to me with the walnut face either. The binding sets it off nicely. Curlie maple would look real smick. Cheers Alan |
|
| Author: | Mackie [ Thu Jan 03, 2008 1:44 pm ] |
| Post subject: | |
Thanks Alan. I tried to come up with something a little different . Like you, I used mostly hand tools. The only power tool I used was a PC router with a pattern following bit in a 3/4" plywood table that I made to shape the veneer and poplar. All of the angled cuts where made with a Japanese Ryoba Saw that I recently brought. Ryoba Saws are amazing! The poplar doesn't look too bad. Anyone have any thoughts on using kiln dried poplar for the peghead to contrast with walnut back and sides? |
|
| Author: | ozziebluesman [ Thu Jan 03, 2008 10:45 pm ] |
| Post subject: | |
Mackie, what model Japanese Ryoba Saw did you purchase. I need a good hand saw myself. The teneon saw I have been using is only a cheap saw and jams often. Cheers Alan |
|
| Author: | Mackie [ Fri Jan 04, 2008 3:17 am ] |
| Post subject: | |
That did'nt work. The saw is called Harima- Diazo Ryoba saw ($56.95)and the url is www.toolsforworkingwood.com |
|
| Author: | Mackie [ Fri Jan 04, 2008 1:19 pm ] |
| Post subject: | |
I agree Todd, that's why I ordered a curly maple blank earlier today. Thank you. Ron Mack |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|